Amination of Heteroaryl Chlorides: Palladium Catalysis or SNAr in Green Solvents?

The reaction of heteroaryl chlorides in the pyrimidine, pyrazine and quinazoline series with amines in water in the presence of KF results in a facile SNAr reaction and N-arylation. The reaction is less satisfactory with pyridines unless an additional electron-withdrawing group is present. The results showed that the transition-metal-free SNAr reaction not only compares favourably to palladium-catalysed coupling reactions but also operates under environmentally acceptable (“green”) conditions in terms of the base and solvent.


Introduction
The formation of aryl CÀN bonds is a fundamental process within organic chemistry, and the product N-arylamines are present in various natural products and pharmaceutical molecules. [1] Examples include the well-known clinically used kinase inhibitors Imatinib and Gefitinib ( Figure 1). Recent analyses showed heteroatom alkylations and arylations to be the largest single class of transformations used in medicinal chemistry, and heteroaryl N-arylations make up a significant subclass of these transformations. [2,3] Classically, these structures have been accessed through nucleophilic aromatic substitution (S N Ar) reactions on appropriately activated substrates, [4] although poor substrate scope and reactivity are major limitations to this method. Alternatively, the copper-mediated amination of halobenzenes, discovered by Ullmann in 1903 and shown to be catalytic by Goldberg three years later, can also be used for the synthesis of a range of N-aryl compounds, and although the original methodology had limitations, recent developments have resulted in substantial improvements. [5] However, the most significant breakthrough in this area came in 1994 when Buchwald et al. and Hartwig et al. independently developed a palladium-catalysed N-arylation reaction. [6,7] With its improved substrate scope and functional group tolerance, the Buchwald-Hartwig amination has become a fundamental part of modern organic chemistry. [8] However, precious metals are expensive and dwindling resources, and although the success of palladium-catalysed reactions has revolutionised N-arylation chemistry, there is a risk that they are used without due consideration of alternatives. For instance, 2-chloropyrimidine is 10 14 -10 16 times more reactive than chlorobenzene in terms of its ability to undergo S N Ar reactions; [9,10] however, an examination of the recent literature reveals that even such reactive substrates are subjected to palladium-catalysed amination reactions. Some recent examples of the palladium-catalysed amination of 2-chloropyrimidine and chloropyrazine are shown in Scheme 1, [11][12][13][14][15][16] and although these reactions, some of which are performed under fairly forcing conditions with non-trivial ligands, proceed in good yield, it does beg the question as to whether palladium is really needed for such highly activated substrates. The literature contains many examples of activated heteroaromatic chlorides reacting readily under S N Ar conditions, so the fact that such processes appear to have been side-lined in favour of their palladium-mediated counterparts puzzled us. Thus, we sought to optimise the coupling of heteroaromatic chlorides with amine nucleophiles under S N Ar conditions with a view to defining pa-The reaction of heteroaryl chlorides in the pyrimidine, pyrazine and quinazoline series with amines in water in the presence of KF results in a facile S N Ar reaction and N-arylation. The reaction is less satisfactory with pyridines unless an additional electronwithdrawing group is present. The results showed that the transition-metal-free S N Ar reaction not only compares favourably to palladium-catalysed coupling reactions but also operates under environmentally acceptable ("green") conditions in terms of the base and solvent. [a] K. Walsh, Prof. Dr. C. J. Moody rameters that not only resulted in comparable yields to those given by the published palladium-catalysed methods but also operated under environmentally acceptable conditions in terms of the base and solvent. We now report the results of this detailed study.

Results and Discussion
The reaction of chloropyrazine with a secondary amine morpholine to yield morpholinopyrazine (1) was taken as a simple test reaction to screen a range of solvents and bases, although from the outset we limited ourselves to solvents that are gen-erally accepted as "green". [17] Solvents with environmental or toxicity alerts were disregarded, and as a result of previous literature, [11,14] caesium carbonate was chosen initially as the base for these reactions. Although caesium carbonate sometimes creates problematic waste streams on large scale, its solubility made it a good starting point for these studies. Organic solvents were found to be generally ineffective for chloropyrazine reactions ( Table 1, entries 1-6), although they are better in the reaction of 2-chloropyrimidine and yield 2-morpholinopyrimidine (2) (data shown in the Supporting Information). However, for both the chloroheterocycles, the best result was obtained by using water as a solvent, which gave both the highest yield and the cleanest reaction mixtures; in most cases, the product required only a simple extraction with isopropyl acetate. Because the reaction mixture is not homogeneous, this unexpected result could be attributed to an "on-water" effect. [18] Yields were improved from 33 % to 58 % (Table 1, entry 6) by increasing the temperature to 100 8C. Water is not automatically a green solvent. For any given reaction, consideration needs to be given to how wastewater is to be handled-whether it is energy intensive to clean or whether contaminated aqueous streams have to be incinerated in which other waste solvent streams could be recycled or productively burnt to generate heat and power. However, if multiple factors are weighed, [17] water is often one of the more benign choices. Isopropyl acetate was chosen for extractions on the basis that it can be We then investigated the reactions of chloropyrazine with morpholine in water with respect to the base (Table 1, entries 7-15). Organic bases proved inefficient in water (entries 7 and 8), and moderate yields were obtained with other carbonates or potassium phosphate bases (entries 9-11). Potassium fluoride was found to be the most effective base and was thus investigated further. Reducing the amount of base to 1 equiv. dramatically lowered the yield (entry 13); however, only a small increase in yield was observed by increasing the amount to 3 equiv. (entry 14). However, with 2 equiv. of potassium fluoride in water at reflux (entry 12), the highest yield of 70 % of 1 was achieved. Reaction times were reduced dramatically by performing the reaction in a microwave reactor for 30 min at 150 or 175 8C (63 % and 81 % yield, respectively). Inductively coupled plasma mass spectrometry (ICP-MS) analysis was performed to determine what levels of other metals were present in the sample of potassium fluoride. Copper could not be detected at a limit of 24 ppb, and palladium was not detected at a limit of 10 ppb.
These results are favourably comparable to those obtained with the palladium-catalysed variants that produced 1 in 86 % yield with Pd-PEPPSI, Cs 2 CO 3 in 1,2-dimethoxyethane (DME) at 80 8C (Scheme 1 d) [14] or in 68 % yield with [Pd(cinnamyl)Cl] 2 , Mor-Dal-Phos, NaOBu t , KOH, and H 2 O at 1108C (Scheme 1 e). [16] However, other researchers have also found that the palladium catalyst is unnecessary and the reaction of chloropyrazine with morpholine proceeds at 130 8C in DMSO. [19] With the useful KF-in-water conditions now established, chloropyrazine and 2-chloropyrimidine were screened against a wide range of primary and secondary amines as well as anilines and NH heteroaromatic compounds; they were selected because they contain a range of functional groups that are relevant to contemporary medicinal chemistry and yielded the corresponding N-arylamines 1-23 (Table 2 and Figure 2). As expected, reactions with the more reactive 2-chloropyrimidine generally produced higher yields (2-chloropyrimidine is % 100 times more reactive than chloropyrazine) [9] and reacted in moderate to excellent yield with primary and secondary amines ( Table 2, entries 1-11). In the case of a-methylbenzylamine (entry 5), HPLC demonstrated that there was no loss of enantiomeric excess in the final product (ee > 98). With p-anisidine (entry 12), the yield of 86 % was comparable with that obtained through the corresponding palladiumcatalysed amination [Pd(OAc) 2 , Xantphos, dioxane, microwave, 160 8C, 83 %; Scheme 1 a]. [11] However, the reaction was poor with ortho-substituted anilines and 2-aminothiazole not reacting. Chloropyrazine gave moderate to excellent yields with electron-rich primary and secondary amines, but was unreactive with all anilines and NH heterocycles examined. Reaction times can be reduced again by conducting the reaction in a microwave reactor for 60 min at 175 8C (entries 1 and 4). The structures of the products 1-23 of amination of chloropyrazine and 2-chloropyrimidine with the range of amines are shown in Figure 2.
In the case in which direct comparison is possible, our amination method involving KF in water can be compared with the palladium-catalysed protocols outlined in Scheme 1 (  [20] which are comparable to the slightly poorer yields of 62 % and 83 % obtained under our conditions ( Table 2, entries 14 and 15). In other cases, the transitionmetal catalyst is clearly beneficial. Although chloropyrazine does not react readily with 4-methoxyaniline under our S N Ar conditions ( Table 2, entry 12), palladium catalysis with the BrettPhos [2-(dicyclohexylphosphino)3,6-dimethoxy-2',4',6'-triisopropyl-1,1'-biphenyl] ligand results in a high yield of the coupled product. [21] Given the high reactivity of 2-chloropyrimi-dine towards nucleophilic attack, it is not surprising that there are other examples of the S N Ar process involving amine nucleophiles (pyrrolidine, [22] cyclohexylamine and 4-methoxybenzylamine), [13] which in combination with our own results reinforce the idea that precious metal catalysis is not needed for amination reactions with such highly activated heteroaryl halides.
From this list of amines, seven examples were chosen to be tested against other pyrimidines in comparison to 2-chloropyrimidine (Table 3). Unsurprisingly, 2-bromopyrimidine showed similar reactivity; however, the reactions with 4-chloro-2,6-di-  aminopyrimidine resulted in unpredictable yields, possibly as a result of solubility issues. 4-Chloroquinazoline gave good to excellent yields in all cases, which is in line with its well-known reactivity in S N Ar reactions, for example in the synthesis of 4-anilinoquinazolines that are used as kinase inhibitors. [23] The structures of the new products 24-33 obtained are shown in Figure 3. The same seven representative amines were also reacted with halopyridines under the KF/water conditions (Table 4), even though 2-chloropyridine is approximately 10 8 times less reactive towards nucleophiles than 2-chloropyrimidine under S N Ar conditions. Hence, the reactions of the amines with 2-chloropyridine were generally unsatisfactory, although, as expected for an S N Ar reaction, 2-fluoropyridine resulted in better yields. If the pyridine substrate contained an additional electron-withdrawing group such as trifluoromethyl or nitro, these substituted pyridines demonstrated reactivities similar to pyrimidines. 2-Chloro-5-nitropyridine gave good results with all the amines examined. The structures of the wide range of N-pyridylamines 34-49 obtained are shown in Figure 4.
Although 2-bromopyridine is reported to react with pyrrolidine under microwave irradiation, [22] it is clear that in the absence of additional activation, 2-halopyridines represent the limit of what will undergo facile amination reactions under our simple S N Ar conditions. In contrast, both 2-bromo-and 2-chloropyridine undergo coupling under a range of palladium-catalysed conditions with, for example, cyclohexylamine and pyrrolidine, [21] with morpholine [12,16] and with 4-methoxyaniline (63 %). [24] Conclusions Although palladium-catalysed Narylation amination reactions have undoubtedly made a major impact on synthetic organic chemistry, there are examples of reactions involving activated halides, in which it could appear that the use of transition metals was unnecessary. We have addressed this issue of over-reliance on palladium catalysis in organic chemistry in a range of nucleophilic aromatic substitution reactions with activated heteroaryl halides to synthesise various heteroaryl amine substrates. A set of conditions has been developed with potassium fluoride and water at reflux for 17 h that allow for S N Ar chemistry to be performed, without the use of palladium catalysis and with various heteroaryl halides and amines. The results showed that the transition-metal-free S N Ar reaction not only compares favourably to palladium-catalysed coupling reactions but also operates under environmentally acceptable conditions in terms of the base and solvent.  Whilst we believe that this methodology offers an improvement over many Pd-catalysed reactions, the compatibility of fluoride ions with other reagents and waste streams (on a large scale) should be considered.

Experimental Section
General Procedure: To a Reacti-Vial (Thermo Scientific, 5 mL) was added aryl halide (1.75 mmol), amine (1.75 mmol), potassium fluoride (3.50 mmol) and the solvent (1 mL); the resulting mixture was heated to 100 8C for 17 h on a heating block. Upon cooling, the mixture was quenched with an aqueous potassium carbonate solution (40 mL) and extracted into isopropyl acetate (2 30 mL). The organic extracts were then combined and washed with brine before they were dried over sodium sulfate and the solvent evaporated under reduced pressure. If necessary, purification was performed by using column chromatography over silica gel (light petroleum/ethyl acetate 4:1).