Liquid Chromatographic Determination of Flavoxate HCl in Pharmaceutical Formulation

The objective of the study was to develop a high performance liquid chromatography (HPLC) method using ultra violet (UV) detection for the determination of flavoxate HCl in bulk and solid dosage forms by using ibuprofen as the internal standard. Eclipse C18 column (150 mm × 4.6 mm, 5 μm) was used as the stationary phase with a mixture of acetonitrile : 0.1% formic acid in water (75: 25 v/v) as the mobile phase. The response of the drug was linear in the concentration range of 1 – 250 μg/ml. Limit of detection and Limit of quantification were found to be 0.23 μg/ml and 0.69 μg/ml, respectively. The percentage of recovery ranged between 97.4 and 101.3%. The factors affecting column separation of the analyte were studied. The results demonstrated that this method is reliable, reproducible, and suitable for routine quantitative use.


Chromatographic conditions
The HPLC Agilent 1200 system (Germany) was equipped with an auto injector (100 μl syringe) and connected to a variable diode array wavelength detector and recorder. A Zorbax eclipse XBD-C18 reversed phased column (150 mm x 4.6 mm. i.d.) bonded on to 5 µm silica gel, manufactured by Agilent, was used for analysis. A mixture of acetonitrile : 0.1% formic acid in water (75 : 25 v/v, pH 3.0) was used as the mobile phase. The flow rate was 0.8 ml/ min, wavelength was 218 nm, and the injection volume was 20 μl. The analysis was carried out at ambient temperature.

Reagents
All the chemicals were of analytical grade and used without further purification. The water was distilled and deionized by passing it through the water purification system. HPLC grade Acetonitrile (Chromasolv) and AR grade formic acid from Sigma Aldrich (Switzerland) were used in this study. The standard drug samples of the flavoxate HCl and ibuprofen used were supplied by Mankind Pharma Ltd., India.

Standard and sample preparation
Standard stock solution at a concentration of 1 mg/ml FLX was prepared by dissolving an appropriate amount of the standard drug in the mobile phase. Internal standard ibuprofen (IBU) solution was prepared by dissolving 10 mg of IBU in 10 ml of the mobile phase. Twenty tablets of FLX as HCl salt each containing 200 mg were weighed and powdered. A quantity equivalent to 10 mg of FLX, as HCl salt powder, was weighed and transferred to a 10 ml volumetric flask containing 8 ml of the mobile phase and sonicated for 10 minutes. Subsequently, the volume was made up to the mark with the mobile phase. The solution was filtered using a nylon 0.45 µm membrane filter. This solution was diluted with the mobile phase to get the concentration in the Beers range.

Method validation
The method validation parameters, such as, specificity, linearity, accuracy, precision, limit of detection, limit of quantification, and robustness were verified as per the International Conference on Harmonization (ICH) guidelines. [14] Specificity The specificity of the method was confirmed by comparison of chromatograms obtained from the standard and the samples.

Linearity and range
Appropriate aliquots of standard stock solution were taken in 10 ml volumetric flasks. Internal standard IBU solution (0.5 ml) was added to all the volumetric flasks and the volume was brought up to the mark with the mobile phase to get the following concentrations: 1, 10, 50, 100, 150, 200, and 250 μg/ml of FLX and 50 μg/ml of IBU. Twenty microliters of the standard and sample were injected and the chromatograms were recorded.

Accuracy (% Recovery)
The accuracy study was carried out by the standard addition method. Known amounts of standard solution of FLX (50, 100, and 150 μg/ml) were added to a sample solution of FLX (50 μg/ml), with IBU as the internal standard (50 μg/ml). Each solution was injected in triplicate and the

Precision
Standard solutions having concentrations of 1, 10, 50, 100, 150, 200, and 250 μg/ml of FLX and 50 μg/ml of IBU were prepared. For the intra-day studies, three repeated measurments of these solutions were carried out within a day and %RSD was calculated. In the inter-day variation studies, three repeated measurements of the same solutions were carried out on three consecutive days and %RSD was calculated.

Limit of detection and limit of quantification
The limit of detection (LOD) and limit of quantification (LOQ) were calculated from the standard deviation of responses and slopes using signal-to-noise ratio as per ICH guidelines. [14] Robustness Robustness of the method was studied by changing the extraction time of FLX, from dosage form by five minutes, composition of mobile phase by 2% of organic phase, flow rate by 0.1 ml/min, and wavelength by 1 nm.

System suitability test
System suitability tests were used to verify the resolution and repeatability of the system. The parameters used in this test were asymmetry of the chromatographic peak, peak resolution, and repeatability, as relative standard deviation (RSD) of the peak area, for repeated injections. The precision of the instrument was checked by repeatedly injecting a solution of FLX (100 μg/ml).

RESULTS AND DISCUSSION
Chromatographic conditions were developed empirically by selecting various solvents such as water, acetonitrile, and methanol in different concentrations, and the retention time and resolution were assessed to get optimum conditions. Under the established chromatographic condition, flavoxate HCl and internal standard (IS) peaks were well-resolved.
As the system suitability parameters such as tailing factor and theoretical plate numbers were within the acceptable limits, the resolution of peaks were considered optimum. Retention time for FLX was 1.44 minutes, whereas, for IBU it was 3.50 minutes [ Figure 2], indicating the rapid analysis of FLX. The calibration curves were constructed by plotting ratios of the peak areas of FLX and peak areas of IBU versus concentration of FLX, and the regression equations were calculated. Each response was the average of three determinations. The results [ Table 1] obtained showed that the linearity range was 1 -250 μg/ml. The corresponding regression equation was found to be: Y = 0.022 (X) + 0.0052 (Y is peak area ratio of FLX to IS and X is FLX concentration) with a correlation coefficient of 0.9995.
The recovery study showed that the mean recovery was 99.6% and the RSD for three samples was lower than 2.0%.
The RSD values of intra-day and inter-day were found to be in the range of 0.05 -0.43 and 0.15 -0.65, respectivly. As these parameters were within the acceptable range, it was inferred that the method was precise. The accuracy of the developed method was assessed by the standard addition method and the RSD was found to be within the acceptable limit [ Table 2]. The limit of quantification (LOQ) of the method, defined as the minimum concentartion that could be measured, was found to be 0. 69 μg/ml. The limit of detection (LOD) was 0.23 µg/ml [ Table 1]. The method was found to be robust as the results were not significantly affected by the slight variation in the extraction time, composition of mobile phase, flow rate, and wavelength.
The chromatographic parameters such as selectivity and peak symmetry were within the range, and %RSD of repeatability was found to be 0.84, which was found to be satisfactory. The number of theoretical plates and the tailing factor were observed to be satisfactory [ Table 1].

Analysis of marketed formulation
The proposed validated RP-HPLC method was successfully  Table 3]. Furthermore, the matrix components, for example, the excipients, did not interfere with the analyte.

CONCLUSION
The validated RP-HPLC method employed here has proved to be rapid, simple, specific, accurate, precise, sensitive, and robust. It can be successfully used for the routine analysis of FLX in bulk and in solid dosage form.